Dino Card

Hi everyone, today I'm the Designer at Card A Day Blog. I pulled out some of my scrap paper to make today's card.  I have the cutting instructions below. 

 

I layered the top and bottom then added my punched border.  I hand cut a few banner to put behind my punched background.  I stamped the dino then added him to the top. 

 

For the inside I stamped the dino again (he's hiding on the other side of the paper) and added a border to the top.

 

Tomorrow Jill Figley is the Designer so be sure to stop back to see her.

 

Thanks for stopping by.

1 card for OWH

Cutting Instructions:
Card Base: 8 1/2" x 5 1/2", scored at 4 1/4"
Brown: 5 3/8" x 4 1/8"
Polka Dots: 4" x 2 1/2"
Green: 4" x 2 3/4"
Red scallop trim 4 x 1" (after punching the edge)
Inside Card:  5 1/4" x 4"
Green on top: 4 x 1/2"

Recipe:
Cardstock: DCWV - brown, blue, white and green (card base); Pattern papers - unknown scraps
Stamp: Snag' em Stamps - Triceratops
Ink: Stampin' Up - Not Quite Navy
Punches: Stampin' Up -  Decorative Label and scallop border
Misc.: Adhesive and scissors